Lr-baggs M1A Manuel d'utilisateur télécharger pdf (Page 4)

3.2 Pickup installation: Be sure there’s a battery inserted into the

battery holder. Then plug the strapjack harness into the pickup.

Now loosen the clamp screws on either end of the pickup’s top

plate until the clamps are open enough to accommodate the

guitar’s top thickness. Then slide the pickup into the sound hole

and tighten the screws. Be sure to secure the wire with the two

self-stick wire clips provided so that it does not hit the inside of

the guitar during stage movement.

Tighten the screws snugly, but don’t overdo it -- this can damage

the pickup or guitar nish. If you are concerned about the

possibility of the M1 Active damaging the instrument’s nish,

consider applying thin cork pads (not included) between the

clamp and guitar. However, note that the clamps have been left

unpadded to improve coupling between the pickup and guitar

body. Because the M1 Active reads the top resonances that

provide depth and warmth, using cork pads may dampen this

sensitivity and adversely aect the pickup’s responsiveness.

4 . U S E R ‘ S G U I D E

4.1 Plugging in: The M1 Active will plug into practically anything

with good results. If you want EQ or use a direct box, our Para DI and

Venue DI provide both EQ and DI features. Plugging in turns

the circuit on and unplugging turns the circuit off. If you want

your battery to last a good long time, remember to unplug when

you’re done.

1 2 3 4 5 6

Pas de commentaire

Lr-baggs M1A Manuel d'utilisateur Page 4